The short answer
Use 1:1:1 when you want a starter at its peak in 4 to 6 hours. Use 1:2:2 for 6 to 8 hours, and 1:5:5 for 8 to 12 hours. At 75°F (24°C), those are the windows for a healthy starter. A cooler kitchen stretches every one of them, and a warmer kitchen shortens them.
The ratio is the only thing you control that changes the peak time by hours instead of minutes. If you want your starter ready when you wake up, feed it 1:5:5 before bed. If you want it ready after lunch, feed it 1:1:1 in the morning.
To turn any ratio into grams for your jar, use the starter feeding calculator.
What the three numbers mean
A feeding ratio is starter to water to flour, by weight. In 1:1:1, you keep 20 g of starter, add 20 g of water and add 20 g of flour. In 1:5:5, you keep 20 g of starter, add 100 g of water and add 100 g of flour. The first number is always the starter you keep, so a bigger second and third number means a bigger dilution.
Equal water and flour gives a starter at 100% hydration, which is thick like pancake batter. That is the usual home setup. If you feed a stiffer or wetter starter, the peak times below shift a little, and the calculator lets you set the hydration.
Weigh everything. Measuring flour by the cup can differ by 30% between scoops, and that error is enough to change the peak time by hours.
Why a bigger ratio peaks later
After a feed, the yeast and bacteria in the starter multiply until they run low on food. A 1:1:1 feed leaves half the jar as old starter, so the population is already large and it eats through the new flour quickly. A 1:5:5 feed leaves one part in eleven, so the population has to grow much further before it peaks.
A larger feed also gives the starter more flour to work through, so it rises higher and stays active longer. Starters on large ratios tend to be milder, because the acid builds more slowly relative to the yeast. Starters fed 1:1:1 and left sitting turn sour sooner.
Starter ratio chart with peak times
Each cell is the typical time from feeding to the peak, when the starter has about doubled or tripled and the surface is domed. The times assume a starter at 100% hydration, fed with white or mixed flour, that is healthy and fed on a regular schedule. Temperature means the temperature of the jar, which is usually the room.
Treat every number as a range to start watching, not a deadline. A young starter under a month old runs slower than the chart. A rye or wholegrain feed runs a bit faster.
| Temperature | 1:1:1 | 1:2:2 | 1:5:5 | 1:10:10 |
|---|---|---|---|---|
| 68°F / 20°C | 6 to 8 h | 8 to 11 h | 12 to 16 h | 16 to 24 h |
| 72°F / 22°C | 5 to 7 h | 7 to 10 h | 10 to 14 h | 14 to 18 h |
| 75°F / 24°C | 4 to 6 h | 6 to 8 h | 8 to 12 h | 12 to 16 h |
| 82°F / 28°C | 3 to 4 h | 4 to 6 h | 6 to 8 h | 9 to 12 h |
The 1:10:10 column is for long gaps, such as a feed before work on a cool day. It is also what many bakers use for a once-a-day schedule in a warm kitchen. Above 82°F, even 1:10:10 can peak and collapse in under 9 hours.
How to tell it has peaked
Put a rubber band on the jar at the level of the starter right after the feed. At the peak, the starter has grown by 2 to 3 times, the top is domed and bubbles cover the surface and the sides. When the dome flattens and starts to dip in the middle, the starter has passed its peak and is on its way down.
Bake with it from the peak up to about an hour after. A starter that has fallen still works, but it is hungrier and more acidic, so a dough made from it ferments slower and tastes sharper. Feed it again and wait.
Choosing a ratio for your schedule
Same-day bake. Feed 1:1:1 or 1:2:2 in the morning so the starter peaks 4 to 8 hours later, then mix your dough. At 75°F, a 1:1:1 feed at 7 am gives you a peak starter between 11 am and 1 pm. The sourdough schedule planner can work backward from the time you want bread.
Overnight. Feed 1:5:5 before bed. At 72 to 75°F, it peaks 8 to 14 hours later, which covers most sleeping hours. If your kitchen runs cool at night, use 1:5:5. If it runs warm, use 1:10:10 so the starter does not peak at 3 am and collapse.
Fridge storage. If you bake once a week, keep the starter in the fridge. The fridge storage guide has the full weekly routine. Feed it 1:5:5, let it rise for about an hour at room temperature, then refrigerate it. It will keep for a week or two without another feed. Many bakers keep only a spoonful in the jar and build the amount they need before each bake.
Building the amount you need. Work out the starter your recipe calls for, then pick a ratio that gives that much at the peak. For a recipe that needs 100 g of starter at 1:5:5, you keep about 9 g and add 45 g of water and 45 g of flour. The sourdough calculator shows how much starter a loaf needs, and the feeding calculator works out the grams.
Common mistakes
Using starter straight from the fridge. Cold starter is sluggish, and a dough built from it can take hours longer to rise. Take it out, feed it, and wait for it to peak at room temperature. A starter that has been in the fridge for more than a week often needs two feeds before it is fully active.
Too little flour. A feed with less flour than water is a thin starter, and it runs out of food early, peaks lower and collapses sooner. Weigh water and flour in equal amounts unless you are deliberately changing hydration.
An inconsistent schedule. A starter fed at 8 am one day and 3 pm the next has a different peak every time. Pick a ratio, pick a time and keep to it for a week. After that, note how long your starter takes to peak and adjust the ratio, not the time.
Judging by the clock alone. The chart gives a range. A starter at the same ratio can peak an hour earlier or later depending on the flour, the water temperature and how long ago it was last fed. Watch the jar.
Discarding too little. If you keep 100 g of starter and feed it 1:1:1, the jar fills up fast and the feed is mostly old starter. Keep a small amount, 10 to 20 g, and feed that. A smaller kept amount also gives a clean 1:5:5 or 1:10:10 feed without needing a huge jar. For the discard you do make, see what to do with sourdough discard.
Adjusting when your starter runs fast or slow
If your starter peaks earlier than the chart, move to a bigger ratio or put the jar somewhere cooler. If it peaks later, use a smaller ratio, move the jar somewhere warmer, such as an oven with only the light on, or swap some of the flour for wholegrain or rye.
A starter that is slow at every ratio is usually young, underfed or too cold. Feed it 1:1:1 twice a day at room temperature for several days and check again.
Frequently asked questions
What is a 1:1:1 sourdough starter feeding?
It means one part starter, one part water and one part flour by weight. For example, 20 g of starter, 20 g of water and 20 g of flour. At 75°F (24°C) it usually peaks in 4 to 6 hours.
What is the difference between 1:1:1 and 1:5:5?
A 1:5:5 feed dilutes the starter five times more, so it takes longer to peak, usually 8 to 12 hours at 75°F (24°C) instead of 4 to 6. It suits overnight feeds. A 1:1:1 feed suits a same-day bake.
How long does it take for a sourdough starter to peak?
It depends on the ratio and temperature. At 75°F (24°C), a healthy starter peaks in about 4 to 6 hours at 1:1:1, 6 to 8 hours at 1:2:2 and 8 to 12 hours at 1:5:5. Cooler rooms take longer.
What ratio should I feed my starter overnight?
Most bakers use 1:5:5 in a kitchen around 70 to 75°F (21 to 24°C). In a warm kitchen, use 1:10:10 so the starter does not peak and collapse while you sleep.
How do I feed a starter that lives in the fridge?
Take it out, discard most of it and feed it. A 1:2:2 or 1:5:5 feed at room temperature works well. Wait for it to peak before baking. If it was in the fridge for over a week, feed it twice first.
Is it fine to use my starter after it has peaked?
Yes, within an hour or so. Past that, the starter is hungry and acidic, so the dough ferments slower and tastes sharper. Feed it again and use it at the next peak.
How much starter should I keep before feeding?
Keep 10 to 20 g for a home starter. A small kept amount keeps the jar small, wastes less flour and lets you use larger ratios. Use the starter feeding calculator to get the grams for any ratio.
